Black Box DVI 사용자 설명서
12
Model AC2000A
12
3.2.2.3 Enable output boost:
Output boost can be enabled for the output signal equalization over a long
cabling when desired.
cabling when desired.
Command ........................................... Response
ASCII e or E (Hex 65 or 45).................Enable boost (1=DVI – 2=UTP)
ASCII 1 (or Hex 31) .................................................. DVI boost enabled
ASCII 2 (or Hex 32) ..................................................UTP boost enabled
ASCII e or E (Hex 65 or 45).................Enable boost (1=DVI – 2=UTP)
ASCII 1 (or Hex 31) .................................................. DVI boost enabled
ASCII 2 (or Hex 32) ..................................................UTP boost enabled
3.2.2.4 Disable output boost:
Output boost can also be disabled for the output signal equalization over a
long cabling when desired.
long cabling when desired.
Command ........................................... Response
ASCII d or D (Hex 64 or 44)...............Disable boost (1=DVI – 2=UTP)
ASCII 1 (or Hex 31) ................................................. DVI boost disabled
ASCII 2 (or Hex 32) .................................................UTP boost disabled
ASCII d or D (Hex 64 or 44)...............Disable boost (1=DVI – 2=UTP)
ASCII 1 (or Hex 31) ................................................. DVI boost disabled
ASCII 2 (or Hex 32) .................................................UTP boost disabled
3.2.2.5 Read EDID Information:
Read EDID information from the currently selected EDID routing selection
Command ........................................... Response
ASCII r or R (Hex 72 or 52)....................................................................
Reading EDID info from DVI-Local (or UTP-Remote) Device
Reading EDID info from DVI-Local (or UTP-Remote) Device
Or
Reading EDID info from Emulate Default (or Emulate Learned) memory
Output is in a tabular format similar to below:
Output is in a tabular format similar to below: