Maytag MGD6000X 설치 설명서

The following instructions are for models with a round-shaped 

door. For models with a square shaped door, an additional kit is 

needed. Please contact your retailer, or see “For Assistance or 

Service” in your Use and Care Guide.

#2 Phillips screwdriver

Min. 8” long Torx

®

 T25 

screwdriver

Using a Torx

®

 T25 screwdriver, remove the 4 screws securing 

the door hinge to the dryer and lift up and out to remove the 

door. Place the door on a soft towel or other non-scratch 

surface. Reinstall the 4 screws in the holes. 

Using a Torx

®†

 T25 screwdriver, remove the 2 screws securing 

the  door strike to the door frame of the dryer. Rotate the 

strike 180° and attach to the opposite side of dryer door 

frame, as shown.

Position the door with the inside of the door facing up.  

Using a Phillips screwdriver, remove the 10 screws securing 

the inner door to the outer door. Lift off the inner door and  

set aside.