Netgear FS726TP 사용자 가이드
Smart Switch Series Software Manual
4-10
Web-Based Management Interface
The Trunk Table shows all four trunking groups are set disabled by default. For each trunk group,
trunk members are pre-set for selection.
trunk members are pre-set for selection.
To select Trunk members for a Trunk group, click Apply to activate the new setting
Note:
The selected trunk port setting must set to the same VLAN group.
Switch> Monitor Page
The Monitor feature allows you to configure any port's incoming and/or outgoing traffic to be
mirrored to a pre-defined sniffer port.
mirrored to a pre-defined sniffer port.
Sniffer Mode:
•
.Disable - disable port mirroring globally.
•
.RX - mirroring only the ingress traffic to the designated source ports.
•
.TX - mirroring only the egress traffic to the designated source ports.
•
Both - mirroring both incoming and outgoing traffic on the designated source ports.
•
Sniffer Port: Select one from a pull-down menu.
•
Source Ports: Select any number of ports to be monitored (mirrored). The ports can not be the
Sniffer port
Sniffer port
Switch> Advanced> Jumbo Frame
This page allows you to enable or disable the Jumbo Frame support. Jumbo Frames are not an
approved standard Ethernet frame size, so you will need to ensure that all of your networking gear
can support these non-standard Jumbo Frames to prevent them from being dropped. By clicking
'Help' button on this page, you can see the maximum frame size the switch can carry.
approved standard Ethernet frame size, so you will need to ensure that all of your networking gear
can support these non-standard Jumbo Frames to prevent them from being dropped. By clicking
'Help' button on this page, you can see the maximum frame size the switch can carry.