Netgear gsm7312 사용자 설명서
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Switching Commands
7-47
202-10009-01
config spanningtree forceversion
This command sets the Force Protocol Version parameter to a new value. The <version> can be
one of the following:
one of the following:
•
802.1d - ST BPDUs are transmitted rather than MST BPDUs (IEEE 802.1d functionality
supported)
supported)
•
802.1w - RST BPDUs are transmitted rather than MST BPDUs (IEEE 802.1w functionality
supported)
supported)
•
802.1s - MST BPDUs are transmitted (IEEE 802.1s functionality supported)
Default
802.1s
Format
config spanningtree forceversion <802.1d/802.1w/
802.1s>
config spanningtree configuration name
This command sets the Configuration Identifier Name for use in identifying the configuration that
this switch is currently using. The <name> is a string of at most 32 characters.
this switch is currently using. The <name> is a string of at most 32 characters.
Default
The base MAC address displayed using hexadecimal notation as specified in
IEEE 802 standard.
IEEE 802 standard.
Format
config spanningtree configuration name <name>
config spanningtree configuration revision
This command sets the Configuration Identifier Revision Level for use in identifying the
configuration that this switch is currently using. The <revision> is a number in the range of 0 to
65535.
configuration that this switch is currently using. The <revision> is a number in the range of 0 to
65535.
Default
0
Format
config spanningtree configuration revision <0-65535>
show spanningtree port
This command displays the settings and parameters for a specific switch port within the common
and internal spanning tree. The <slot.port> is the desired switch port.
and internal spanning tree. The <slot.port> is the desired switch port.
Format
show spanningtree port <slot.port>
Port mode
Enabled or disabled.