Netgear gsm7312 사용자 설명서

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software

7-48

Switching Commands

202-10009-01

Port Up Time Since

Counters Last Cleared

Time since port was reset, displayed in days, hours, minutes, and seconds.

STP BPDUs Transmitted

Spanning Tree Protocol Bridge Protocol Data Units sent.

STP BPDUs Received

Spanning Tree Protocol Bridge Protocol Data Units received.

RST BPDUs Transmitted

Rapid Spanning Tree Protocol Bridge Protocol Data Units sent.

RST BPDUs Received

Rapid Spanning Tree Protocol Bridge Protocol Data Units received.

MSTP BPDUs Transmitted

Multiple Spanning Tree Protocol Bridge Protocol Data Units sent.

MSTP BPDUs Received

Multiple Spanning Tree Protocol Bridge Protocol Data Units received.

config spanningtree port migrationcheck

This command forces the specified port to transmit RST or MST BPDUs. The port <slot.port> is
the desired switch port. To set the migration check for all ports with a single command, "all" can
be specified. Note that the forceversion parameter for the switch must be set to 802.1w or 802.1s.

Default

disable

Format

config spanningtree port migrationcheck <slot.port/

all> <enable/disable>

config spanningtree port mode

This command sets the Administrative Switch Port State to a new value for the specified port. The
port <slot.port> is the desired switch port. To enable or disable all ports with a single command,
"all" can be specified. Note that only 4095 ports can be enabled.

Default

disable

Format

config spanningtree port mode <slot.port/all>

<enable/disable>

show spanningtree bridge

This command displays spanning tree settings for the bridge.

Format

show spanningtree bridge

Bridge Priority

Configured value.

Bridge Identifier

Bridge Max Age

TConfigured value.

Bridge Hello Time

Configured value.

Bridge Forward Delay

Configured value.

Bridge Hold Time

Minimum time between transmission of Configuration Bridge Protocol Data
Units (BPDUs).