Netgear gsm7312 사용자 설명서

Routing Commands

8-7

l 

This command configures the ARP count of maximum request for retries. 

The value for <retries> is an integer, which represents the maximum number of request for retries. 
The range for <retries> is an integer between 1-10 retries. 

4 

This command displays all pertinent information about the IP interface. 

A IP address representing the subnet configuration of the router interface. This 

value was configured into the unit. 

A mask of the network and host portion of the IP address for the router interface. 

This value was configured into the unit. 

The administrative mode of router interface participation. The possible values 

are enable or disable. This value was configured into the unit. 

The administrative mode of the specified interface. The possible values of this 

field are enable or disable. This value was configured into the unit.

 

Displays whether forwarding of network-directed broadcasts is enabled or 

disabled. This value was configured into the unit.

Displays whether the interface is active or inactive. An interface is considered 

active if its link is up and it is in forwarding state.

A integer representing the physical link data rate of the specified interface. This 

is measured in Megabits per second (Mbps). 

The burnedin physical address of the specified interface. The format is 6 two-

digit hexadecimal numbers that are separated by colons. 

 

A number representing the maximum transmission unit (MTU) size (in bytes) 

for the interface. The default value is 1500. For the standard implementation the