Netgear gsm7312 사용자 설명서
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
8-8
Routing Commands
202-10009-01
maximum value is 1500 and the minimum value is 576 bytes. This value was
configured into the unit.
configured into the unit.
Encapsulation Type
The encapsulation type for the specified interface. The types are: Ethernet or
SNAP.
config interface encaps
This command configures the link layer encapsulation type for the packet. Acceptable values for
<encapstype> are Ethernet and SNAP. The default is Ethernet.
<encapstype> are Ethernet and SNAP. The default is Ethernet.
Format
config interface encaps <slot.port> <ethernet/snap>
Restrictions
Routed frames are always Ethernet encapsulated when a frame is routed to a
VLAN.
config interface routing
This command enables or disables routing for an interface.
The value for <mode> is either enable or disable.
The current value for this function is displayed under "Show ip Interface" labeled as "Routing
Mode".
Mode".
Default
disable
Format
config interface routing
<slot.port> <enable/disable>
config ip interface mtu
This command sets the default maximum transmission unit (MTU) size (in bytes) for the interface.
For the standard implementation, the range of <mtusize> is a valid integer between 576-1500.
For the standard implementation, the range of <mtusize> is a valid integer between 576-1500.
Default
1500
Format
config ip interface mtu <slot.port> <576-1500>
config ip interface netdirbcast
This command enables or disables the forwarding of network-directed broadcasts.
The value for <mode> is either enable or disable. When enabled, network directed broadcasts are
forwarded. When disabled they are dropped.
forwarded. When disabled they are dropped.
Default
enable