Netgear gsm7312 사용자 설명서

7-22

Switching Commands

This command displays telnet settings.

 

 

This object indicates the number of minutes a telnet session is allowed to remain 
inactive before being logged off.A zero means there will be no timeout. May be 
specified as a number from 0 to 160. The factory default is 5. 

 

Selectable from a pull-down menus for values of from 0 to 5. This object 
indicates the number of simultaneous telnet sessions allowed. The factory 
default is 5. 

Allow New Telnet Sessions   Indicates that new telnet sessions will not be allowed when set to no. The 

factory default value is yes. 

This command specifies the maximum number of telnet sessions that can be established. A value 
of 0 indicates that no telnet session can be established. The range is 0 to 5.

5 

 

This command regulates new telnet sessions. If sessions are enabled, new telnet sessions can be 
established until there are no more sessions available. If sessions are disabled, no new telnet 
sessions are established. An established session remains active until the session is ended or an 
abnormal network error ends it.

enable

This command sets the telnet session timeout value, in minutes. A session is active as long as the 
session has been idle for the value set. A value of 0 indicates that a session remains active 
indefinitely. the time is a decimal value from 0 to 160. 

Changing the timeout value for active sessions does not become effective until the session is 

reaccessed. Any keystroke will also activate the new timeout duration.