Netgear FVS338 참조 가이드

Virtual Private Networking

5-7

•

Local. IP address (either a single address, range of address or subnet address) on your local 
LAN. Traffic must be from (or to) these addresses to be covered by this policy. (Subnet 
address is the default IP address when using the VPN Wizard).

•

Remote. IP address or address range of the remote network. Traffic must be to (or from) these 
addresses to be covered by this policy. (The VPN Wizard default requires the remote LAN IP 
address and subnet mask for a gateway policy).

•

AH. Authentication Header. This specifies the authentication protocol for the VPN header 
(VPN Wizard default is disabled). 

•

ESP. Encapsulating Security Payload. This specifies the encryption protocol used for the VPN 
data (VPN Wizard default is enabled). 

Recent VPN tunnel activity is shown on the IPSec Connection Status screen (accessed by 
selecting VPN from the main menu and Connection Status from the submenu).You can set a Poll 
Interval (in seconds) to check the connection status of all active IKE Policies to obtain the latest 
VPN tunnel activity. The Active IPSec (SA)s table also lists current data for each active IPSec SA 
(Security Association):

•

Policy Name. The name of the VPN policy associated with this SA. 

•

Endpoint. The IP address on the remote VPN Endpoint. 

•

Tx (KBytes). The amount of data transmitted over this SA. 

•

Tx (Packets). The number of packets transmitted over this SA.

•

State. The current state of the SA. Phase 1 is “Authentication phase” and Phase 2 is “Key 
Exchange phase”. 

•

Action. Allows you to terminate or build the SA (connection), if required.