Netgear FVS338 참조 가이드

5-8

Virtual Private Networking

This section describes how to configure a VPN connection between a NETGEAR FVS338 VPN 
Firewall and a NETGEAR FVX538 VPN Firewall. 

Using each firewall's VPN Wizard, we will create a set of policies (IKE and VPN) that will allow 
the two firewalls to connect from locations with fixed IP addresses. Either firewall can initiate the 
connection. 

This procedure was developed and tested using:

•

Netgear FVS338 VPN Firewall 

–

WAN IP address: 10.1.32.41 

–

LAN IP address subnet:192.168.1.1/255.255.255.0 

•

Netgear FVX538 VPN Firewall 

–

WAN1 IP address: 10.1.0.118 

–

LAN IP address subnet: 192.168.2.1/255.255.255.0 

To configure the FVS338 using the VPN Wizard:

1. Select VPN from the main menu and VPN Wizard from the submenu. The VPN Wizard 

screen will display.

2. Check the Gateway radio box to establish a gateway-to-gateway VPN tunnel.

3. Give the new connection a name such as to_fvx.

4. Enter a value for the pre-shared key. 

5. Enter the WAN IP address or Internet name of the remote WAN and the WAN IP Address or 

Internet name of the local WAN. The address type must match.

6. Enter the remote LAN IP address and subnet mask. 

7. Click Apply to create the IKE and VPN policies.