Quantum fc1202 사용자 가이드
Chapter 2 FC1202 Bridge Serial/Telnet User Interface
Perform Configuration
Quantum FC1202 User’s Guide
53
•
Change IP address
(default: 1.1.1.1) changes the FC1202 IP address.
•
Change IP Subnet Mask
(default: 255.255.255.0) changes the FC1202
Subnet mask.
•
Change IP Gateway
(default: 0.0.0.0) changes the IP gateway for the
Ethernet network.
•
Change Ethernet Physical Address
changes the Ethernet physical
address (MAC address).
Caution:
If this configuration setting is incorrectly set, processing
difficulties may occur. Before changing this setting,
evaluate the need for the change and verify the desired
setting. Backing up the FC1202 configuration to an
external file before making changes to this setting is
recommended.
•
Toggle Ethernet Mode
changes the Ethernet mode.
Options include:
• 10 Mb/s only
• 100 Mb/s (half duplex) only
• 100 Mb/s (full duplex) only
• 10/100 MPS (Auto-Neg.)
• 10 Mb/s only
• 100 Mb/s (half duplex) only
• 100 Mb/s (full duplex) only
• 10/100 MPS (Auto-Neg.)
•
Change Hostname
changes the name of the host server.
The name can be any combination of alphanumeric characters, up to
eight characters.
•
Toggle DHCP Configuration
enables or disables support for Dynamic
Configuration Protocol.
When DHCP is enabled, the FC1202 will request a dynamic IP
When DHCP is enabled, the FC1202 will request a dynamic IP
address from the DHCP server on the Ethernet network.
Some DHCP servers allow a lease reservation to be set up for an IP
Some DHCP servers allow a lease reservation to be set up for an IP
address by providing the server with the Ethernet MAC address. The
DHCP server will then provide the same IP address to the FC1202.
This setup can be useful for remote management of the FC1202 such