MicroBoards pf3-1000 사용자 가이드
MICROBOARDS TECHNOLOGY, LLC PF-3 PRINT FACTORY
13
Color Tab
Color Options
The Color Options settings allow you to Print in
grayscale or Print in sepia.
grayscale or Print in sepia.
If grayscale is selected, the High Quality and
Black print cartridge only options are enabled.
High Quality will use the color cartridges to create a
composite black.
Black print cartridge only options are enabled.
High Quality will use the color cartridges to create a
composite black.
Only one of these options can be selected at one
time.
time.
Color Space
The Color Space selection defines the range of colors that
can be printed.
can be printed.
sRGB/sYCC
will be the setting selected
unless your image specifically was created using the
AdobeRGB
standard.
Diameter Settings Tab
The Diameter Settings tab allows you to change
the size of the print image to accommodate the
variety of printable surface area available on
media without having to modify the print image
itself. Moving from non-hub printable media to
hub-printable media, for instance, would only
require that you lower the Inner Diameter setting.
the size of the print image to accommodate the
variety of printable surface area available on
media without having to modify the print image
itself. Moving from non-hub printable media to
hub-printable media, for instance, would only
require that you lower the Inner Diameter setting.
The Enable Masking option must be checked to
use this feature.
use this feature.
The Outer and Inner Diameters will change the
size of the area to be printed. To avoid
excessive ink buildup, these values should never
be set so that the PF-3 Print Factory is printing
off the media.
size of the area to be printed. To avoid
excessive ink buildup, these values should never
be set so that the PF-3 Print Factory is printing
off the media.
The Parameter Unit should remain on the 0.1mm setting for maximum precision.
The default diameter settings are a 118mm Outer Diameter and a 36mm Inner Diameter. If you are
using hub-printable media and the 17mm inner diameter SureThing template, the inner diameter must
be changed to the appropriate diameter before printing.
using hub-printable media and the 17mm inner diameter SureThing template, the inner diameter must
be changed to the appropriate diameter before printing.
NOTE: Masking should always be enabled to avoid printing off the printable surface.