Maytag mmv4205b 설치 설명서

Place the blower unit back into the opening.

CAUTION: Do not pull or stretch the blower unit 
wiring. Make sure the wires are not pinched.

Secure blower unit to microwave with the screw.

Slide exhaust adaptor following the instructions 
show in diagram.

Make sure tape securing damper is removed and 
damper pivots easily before mounting microwave.

Lift damper and Re-screw at same location as (1).

•

You will need to make adjustments to assure 
proper alignment with your house exhaust duct 
after the microwave is installed.

Remove and save screw 
from the panel-outer

Exhaust Adaptor  and Damper is shipped 
after being assembled to the filler-upper.

FOR EASIER INSTALLATION AND PERSONAL 
SAFETY, WE RECOMMEND THAT TWO PEOPLE 
INSTALL THIS MICROWAVE OVEN.

NOTE: If your cabinet is metal, use the nylon 
grommet around the power cord hole to prevent 
cutting of the cord.

NOTE: We recommend using filler blocks if the 
cabinet front hangs below the cabinet bottom shelf.

NOTE: When mounting the microwave oven, thread 
power cord through hole in bottom of top cabinet. 
Keep it tight throughout Steps 1–3. Do not pinch cord 
or lift oven by pulling cord.

Insert a self-aligning screw through top center 
cabinet hole. Temporarily secure the oven by 
turning the screw at least two full turns after the 
threads have engaged. (It will be completely 
tightened later.) Be sure to keep power cord 
tight. Be careful not to pinch the cord, 
especially when mounting flush to bottom of 
cabinet.

Rotate front of oven up 
against cabinet bottom

Lift microwave, tilt it 
forward, and hook slots
at back bottom edge 
onto four lower tabs of 
mounting plate.