Maytag mmv4203d 사용자 설명서

NOTE: If no wall studs exist within the cabinet opening, do not 
install the microwave oven.
See illustrations in “Possible Wall Stud Configurations.”
1. Using a stud finder, locate the edges of the wall stud(s) within 

the opening.

2. Mark the center of each stud, and draw a plumb line down 

each stud center. See illustrations in “Possible Wall Stud 
Configurations.”

These depictions show examples of preferred installation 
configurations with the mounting plate.
NOTE: If wall stud is within 6" (15.2 cm) of the vertical centerline 
(see “Mark Rear Wall” section), only recirculation or roof venting 
installation can be done.

NOTE: Holes are for installation with 1 lag screw into the wall stud 
and 2 toggle bolts through the drywall.

NOTE: Holes are for installation with 2 lag screws into the wall 
studs.

The microwave oven must be installed on a minimum of 1 wall 
stud, preferably 2, using a minimum of 1 lag screw, preferably 2.
1. Using measuring tape, find and clearly mark the vertical 

centerline of the opening.

2. Mark the centerline 14

¹⁄₂" (36.8 cm) down from bottom edge of 

the upper cabinet (or flush line, if upper cabinet has a hanging 
front edge – see illustration).

3. Using a straightedge, draw a level, horizontal line through the 

mark made in Step 2. This represents the top edge of the 
mounting plate.

4. Remove the mounting plate and check the markings:

The top edge line must be 14

¹⁄₂" (36.8 cm) from the bottom of 

the upper cabinet, and must be level.

A

B

B

C

D

E

E

F

D

A

C

C

F

E

E

D

A

A

A

C

D

D

E

B