Maytag mmv4203d 사용자 설명서

1. Disconnect power to outlet.
2. Remove all contents from upper cabinet.
3. Place Upper Cabinet Template against the bottom of the 

upper cabinet, and attach with tape or thumbtacks. Make sure 
the template centerline aligns with the vertical centerline on 
the rear wall.
The “rear wall” arrows must be against the rear wall so that the 
holes cut into the upper cabinet align with the holes in the top 
of the microwave oven.

NOTE: If the upper cabinet has a frame around it, trim the 
template edges so that it fits inside the frame, against the upper 
cabinet bottom. The template has trim lines to use as guides.
4. Make sure the 8

³⁄₄" (22.2 cm) dimension from the rear wall to 

points “D,” “E” and “H” on the template is maintained.

5. Cut the 1

¹⁄₂" (3.8 cm) diameter hole at the circular shaded area 

“G” on the template. This hole is for the power supply cord.

NOTE: If upper cabinet is metal, the supply cord bushing needs to 
be installed around the supply cord hole, as shown.

6. Drill 1/2" (13 mm) holes at points “D,” “E” and “H” on the 

template. These are for three 1/4-20 x 3" bolts used to secure 
the microwave oven to the upper cabinet.

7. Cut 3/4" (19 mm) hole at one corner of the shaded rectangular 

area “F” on Upper Cabinet Template.

8. Using a keyhole saw, cut out the rectangular area.

IMPORTANT: The control side of the microwave oven is the heavy 
side. Handle the microwave oven gently.
1. Place the 1/4-28 x 3

¹⁄₄" flat-head bolts inside upper cabinet 

near the 1/2" (13 mm) holes.

2. Make sure the microwave oven door is closed and taped shut.

3. Using 2 or more people, lift microwave oven and hang it on 

support tabs at the bottom of mounting plate.

NOTE: To avoid damage to the microwave oven, do not grip or 
use the door or door handle while the microwave oven is being 
handled.

4. With front of microwave oven still tilted, thread power supply 

cord through the power supply cord hole in the bottom of the 
upper cabinet.

5. Rotate microwave oven up toward upper cabinet. 

NOTE: If venting through the wall, make sure the damper 
assembly fits easily into the vent in the wall cutout.

A

B

A

B

A