3com MSR 20-20 참조 매뉴얼
1620
C
HAPTER
96: MPLS TE C
ONFIGURATION
C
OMMANDS
Parameter
down: Sets the threshold in percentages for IGP to flood when the bandwidth is
decreasing. When the percentage of available bandwidth decrease exceeds the
threshold, the change is flooded and the traffic engineering database (TEDB) is
updated.
decreasing. When the percentage of available bandwidth decrease exceeds the
threshold, the change is flooded and the traffic engineering database (TEDB) is
updated.
up: Sets the IGP flooding threshold in percentages that applies when the
bandwidth is increasing. When the percentage of available bandwidth increase
exceeds the threshold, the change is flooded and the TEDB is updated.
bandwidth is increasing. When the percentage of available bandwidth increase
exceeds the threshold, the change is flooded and the TEDB is updated.
percent: IGP flooding threshold in percentages, in the range 0 to 100.
Description
Use the mpls te bandwidth change thresholds command to set the IGP
flooding thresholds that apply when bandwidth resources are increasing and
decreasing.
flooding thresholds that apply when bandwidth resources are increasing and
decreasing.
Use the undo mpls te bandwidth change thresholds command to restore
the default.
the default.
The default IGP flooding thresholds in both up and down directions are 10.
Example
# On interface Ethernet 1/0 configure IGP to flood when the percentage of
available bandwidth decrease reaches 100%.
available bandwidth decrease reaches 100%.
<Sysname> system-view
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] mpls te bandwidth change thresholds down 100
mpls te commit
Syntax
mpls te commit
View
Tunnel interface view
Parameter
None
Description
Use the mpls te commit command to submit current MPLS TE tunnel
configuration.
configuration.
The MPLS TE tunnel configuration you made can take effect only after you
perform this command.
perform this command.
Example
# Configure an MPLS TE tunnel and submit the configuration.
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-Tunnel0] tunnel-protocol mpls te
[Sysname-Tunnel0] destination 2.2.2.9
[Sysname-Tunnel0] mpls te commit