3com MSR 20-20 참조 매뉴얼
1626
C
HAPTER
96: MPLS TE C
ONFIGURATION
C
OMMANDS
View
Tunnel interface view
Parameter
None
Description
Use the mpls te loop-detection command to configure the node to perform
loop detection when setting up the MPLS TE tunnel.
loop detection when setting up the MPLS TE tunnel.
Use the undo mpls te loop-detection command to disable loop detection.
Loop detection is disabled by default.
Example
# Configure the node to perform loop detection when setting up tunnel 0.
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-Tunnel0] mpls te loop-detection
mpls te max-link-bandwidth
Syntax
mpls te max-link-bandwidth bandwidth-value [ bc1 bc1-bandwidth ]
undo mpls te max-link-bandwidth
View
Interface view
Parameter
bandwidth-value: Maximum link bandwidth available for RSVP traffic, in the range
1 to 32000000 kbps.
1 to 32000000 kbps.
bc1 bc1-bandwidth: Reservable bandwidth in kbps on the interface, in the range 1
to bandwidth-value.
to bandwidth-value.
Description
Use the mpls te max-link-bandwidth bandwidth-value command to
configure maximum link bandwidth.
configure maximum link bandwidth.
Use the undo mpls te max-link-bandwidth command to remove the
configuration.
configuration.
The configured maximum bandwidth is available for both MPLS traffic and
common best-effort traffic.
common best-effort traffic.
Example
# On interface Serial 1/0 set maximum link bandwidth available for RSVP traffic to
1158 kbps, and the reservable bandwidth to 200 kbps.
1158 kbps, and the reservable bandwidth to 200 kbps.
<Sysname> system-view
[Sysname] interface serial 1/0
[Sysname-Serial1/0] mpls te max-link-bandwidth 1158 bc1 200
mpls te max-reservable-bandwidth
Syntax
mpls te max-reservable-bandwidth bandwidth-value [ bc1 bc1-bandwidth ]