3com MSR 20-20 참조 매뉴얼

C

HAPTER

 129: HWTACACS C

ONFIGURATION

 C

OMMANDS

By default, the source IP address of a packet sent to the server is the IP address of 
the outbound port.

Note that:

■

Specifying a source address for the HWTACACS packets to be sent to the 
server can avoid the situation where the packets sent back by the HWTACACS 
server cannot reach the device as the result of a physical interface failure.

■

If you configure the command for more than one time, the last configuration 
takes effect.

■

The nas-ip command in HWTACACS scheme view is only for the current 
HWTACACS scheme, while the hwtacacs nas-ip command in system view is 
for all HWTACACS schemes. However, the nas-ip command in HWTACACS 
scheme view overwrites the configuration of the hwtacacs nas-ip command.

hwtacacs nas-ip.

# Set the IP address for the device to use as the source address of the HWTACACS 
packets to 10.1.1.1.

<Sysname> system-view

[Sysname] hwtacacs scheme hwt1

[Sysname-hwtacacs-hwt1] nas-ip 10.1.1.1 

primary accounting ip-address [ port-number ]

HWTACACS scheme view

ip-address: IP address of the server, a valid unicast address in dotted decimal 
notation. The default is 0.0.0.0.

port-number: Port number of the server. It ranges from 1 to 65535 and defaults to 
49.

Use the primary accounting command to specify the primary HWTACACS 
accounting server.

Use the undo primary accounting command to remove the configuration.

Note that:

■

The IP addresses of the primary and secondary accounting servers cannot be 
the same. Otherwise, the configuration fails.

■

The HWTACACS service port configured on the device and that of the 
HWTACACS server must be consistent.