3com MSR 20-20 참조 매뉴얼

■

If you configure the command for more than one time, the last configuration 
takes effect.

■

You can remove an accounting server only when no active TCP connection for 
sending accounting packets is using it.

# Configure the primary accounting server.

<Sysname> system-view

[Sysname] hwtacacs scheme test1

[Sysname-hwtacacs-test1] primary accounting 10.163.155.12 49 

primary authentication ip-address [ port-number ]

HWTACACS scheme view

ip-address: IP address of the server, a valid unicast address in dotted decimal 
notation. The default is 0.0.0.0.

port-number: Port number of the server. It ranges from 1 to 65535 and defaults to 
49.

Use the primary authentication command to specify the primary HWTACACS 
authentication server.

Use the undo primary authentication command to remove the configuration.

Note that:

■

The IP addresses of the primary and secondary authentication servers cannot be 
the same. Otherwise, the configuration fails.

■

The HWTACACS service port configured on the device and that of the 
HWTACACS server must be consistent.

■

If you configure the command for more than one time, the last configuration 
takes effect.

■

You can remove an authentication server only when no active TCP connection 
for sending authentication packets is using it.

display hwtacacs.

# Set the primary authentication server.

<Sysname> system-view

[Sysname] hwtacacs scheme hwt1

[Sysname-hwtacacs-hwt1] primary authentication 10.163.155.13 49