3com MSR 20-20 참조 매뉴얼
2452
C
HAPTER
164: U
SER
I
NTERFACE
C
ONFIGURATION
C
OMMANDS
sure? [Y/N] ]:y
[Sysname-ui-vty0]-4]
# Telnet to the device again, the display brief interface loopback command will
be executed automatically before the telnet connection breaks. And the following
information will be displayed:
be executed automatically before the telnet connection breaks. And the following
information will be displayed:
***************************************************************************
All rights reserved (2004-2006)
*
* Without the owner’s prior written consent,
*
* No decompiling or reverse-switch fabricering shall be allowed.
*
**************************************************************************
<Sysname>
The brief information of interface(s) under route mode:
Interface
Link
Protocol-link
Protocol type
Main IP
Loop1
UP
UP(spoofing)
LOOP
--
<Sysname>
authentication-mode
Syntax
authentication-mode { none | password | scheme [ command-authorization ] }
View
User interface view
Parameter
none: Performs no authentication.
password: Performs local password authentication.
scheme: Performs authorization and authentication of AAA. For details about
AAA, refer to “AAA Configuration Commands” on page 1913.
AAA, refer to “AAA Configuration Commands” on page 1913.
command-authorization: Performs command line authorization. HWTACACS
allows per-command authorization. An input command is executed only after it
passes authorization. For details about HWTACACS, refer to “HWTACACS
Configuration Commands” on page 1975.
allows per-command authorization. An input command is executed only after it
passes authorization. For details about HWTACACS, refer to “HWTACACS
Configuration Commands” on page 1975.
Description
Use the authentication-mode command to set the authentication mode when
users log onto the device using the current user interface.
users log onto the device using the current user interface.
By default, the authentication mode is password for TTY (asynchronous
interface), VTY, and AUX user interfaces and is none for Console interfaces.
interface), VTY, and AUX user interfaces and is none for Console interfaces.
Related command:
c
CAUTION: If you configure to adopt AAA authentication (that is, the
authentication mode is scheme.), then the default user level is 0.
authentication mode is scheme.), then the default user level is 0.
Example
# Set that no authentication is needed when users use VTY 0 interface to log onto
the device. (This mode may be insecure.)
the device. (This mode may be insecure.)