3com MSR 20-20 참조 매뉴얼

C

HAPTER

 180: V

OICE

 RADIUS C

ONFIGURATION

 C

OMMANDS

Use the undo password-digit command to restore the default number of digits 
in a password for some access number in the card number/password process.

This command is unavailable for the caller number process with IVR. By default, 
the number of digits in a password for some access number in the card 
number/password process is 6.

Before executing the password-digit command, you must use the 
process-config command to specify the two-stage dialing process for the 
configured access number as card number/password process. The 
password-digit command is available only in access number view.

gw-access-number and process-config.

# Specify the number of digits in a password as 4 for the access number 17909.

<Sysname> system-view

[Sysname] voice-setup

[Sysname-voice] dial-program

[Sysname-voice-dial] gw-access-number 17909

[Sysname-voice-dial-anum17909] process-config cardnumber

[Sysname-voice-dial-anum17909] password-digit 4 

# Restore the default number of digits in a password for the access number 
17909.

[Sysname-voice-dial-anum17909] undo password-digit 

process-config { callernumber | cardnumber | voice-caller }

Access number view

callernumber: Specifies the two stage-dialing process as caller number process. 
After a user dials an access number, the voice gateway will continue to play dial 
tones, prompting for a called number. In this process, the user authentication is 
implemented by identifying the calling number, and no more additional parameter 
configurations are required.

cardnumber: Specifies the two-stage dialing process as card number/password 
process. After a user dials an access number, the voice gateway will continue to 
play prompt tones, requiring the user to enter a card number and password. In this 
process, the user authentication is implemented by identifying the prepaid card 
number and password, and you can configure parameters by using the card-digit, 
password-digit, and redialtimes commands.

voice-caller: Specifies the two-stage dialing process as caller number process with 
IVR. After a user dials an access number, the voice gateway will play prompt tones, 
requiring the user to dial a called number. In this process, the user authentication