3com MSR 20-20 참조 매뉴얼
342
C
HAPTER
21: B
ASIC
DLS
W
C
ONFIGURATION
C
OMMANDS
dlsw bridge-set
Syntax
dlsw bridge-set bridge-set
undo dlsw bridge-set bridge-set
View
System view
Parameter
bridge-set: ID of the bridge set to be mapped to DLSw, in the range of 1 to 63.
Description
Use the dlsw bridge-set command to map the specified bridge set to DLSw.
Use the undo dlsw bridge-set command to remove mapping between the
specified bridge set and DLSw.
specified bridge set and DLSw.
By default, no bridge set is mapped to DLSw.
To enable forwarding frames of a bridge set to the remote end over a TCP
connection, the local bridge set needs to be mapped to DLSw through this
command. This command can be used repeated to map multiple bridge sets to
DLSw.
connection, the local bridge set needs to be mapped to DLSw through this
command. This command can be used repeated to map multiple bridge sets to
DLSw.
For details about bridge set configuration, refer to “Bridging Configuration
Commands” on page 549.
Commands” on page 549.
Example
# Map the bridge set by the ID of 20 connected to DLSw.
<Sysname> system-view
[Sysname] bridge enable
[Sysname] bridge 20 enable
[Sysname] dlsw bridge-set 20
dlsw enable
Syntax
dlsw enable
undo dlsw enable
View
System view
Parameter
None
Role
Local role of LLC2 circuit
■
primary" represents the end that initiated the circuit
■
secondary" represents the end accepted the circuit connection
State
State of the LLC2 circuit
Table 37 Description on the fields of the display llc2 command
Field Description