3com MSR 20-20 참조 매뉴얼
344
C
HAPTER
21: B
ASIC
DLS
W
C
ONFIGURATION
C
OMMANDS
dlsw local
Syntax
dlsw local ip-address [ init-window init-window-size | keepalive keepalive-interval |
max-frame max-frame-size | max-window max-window-size | permit-dynamic |
vendor-id vendor-id ] *
max-frame max-frame-size | max-window max-window-size | permit-dynamic |
vendor-id vendor-id ] *
undo dlsw local ip-address [ init-window | keepalive | max-frame | max-window |
permit-dynamic ] *
permit-dynamic ] *
View
System view
Parameter
ip-address: IP address of the local peer to be created. This IP address must be
reachable.
reachable.
init-window-size: Initial local window size, in the range of 1 to 2,000. The default
is 40 (frames).
is 40 (frames).
keepalive-interval: Interval between keepalive messages, in seconds. The effective
range is 0 to 1,200, and the default is 30 seconds. A value of 0 indicates that no
keepalive message will be sent.
range is 0 to 1,200, and the default is 30 seconds. A value of 0 indicates that no
keepalive message will be sent.
max-frame-size: Maximum frame size in bytes. Effective values include 516, 1,470,
1,500, 2,052, 4,472, 8,144, 11,407, 11,454, and 17,800, and the default is 1,500
bytes.
1,500, 2,052, 4,472, 8,144, 11,407, 11,454, and 17,800, and the default is 1,500
bytes.
max-window-size: Maximum local window size, in the range of 1 to 2,000. The
default is 50 (frames).
default is 50 (frames).
permit-dynamic: Permits non-peer routers to initiate connections to establish
peering relationships dynamically with this router. It is not required to configure a
remote peer for a router established as a local peer with this keyword included in
the command.
peering relationships dynamically with this router. It is not required to configure a
remote peer for a router established as a local peer with this keyword included in
the command.
vendor-id: DLSw vendor identifier, in the range of 00.00.00 to ff.ff.ff. The default
is 00.e0.fc.
is 00.e0.fc.
Description
Use the dlsw local command to create a local DLSw peer.
Use the undo dlsw local ip-address command to remove the specified local
DLSw peer.
DLSw peer.
Use the undo dlsw local ip-address { init-window | keepalive | max-frame |
max-window | permit-dynamic } * command to restore the default parameters.
max-window | permit-dynamic } * command to restore the default parameters.
Deleting a local DLSw peer will automatically delete all its remote DLSw peers.
Establishing a TCP connection is the first step in establishing a DLSw circuit. To
establish a TCP connection, you need to specify the IP addresses of both end
systems across the TCP connection. By configuring a local DLSw peer, you specify
the IP address of the local end across the TCP connection. This is required before a
router can initiate or accept a TCP connection request. A router can only have one
local peer.
establish a TCP connection, you need to specify the IP addresses of both end
systems across the TCP connection. By configuring a local DLSw peer, you specify
the IP address of the local end across the TCP connection. This is required before a
router can initiate or accept a TCP connection request. A router can only have one
local peer.