3com MSR 20-20 참조 매뉴얼

C

HAPTER

 36: B

RIDGING

 C

ONFIGURATION

 C

OMMANDS

# Enable bridge set 1.

<Sysname> system-view

[Sysname] bridge 1 enable 

bridge bridge-set bridging { ip | ipx | others }

undo bridge bridge-set bridging { ip | ipx | others }

System view

bridge-set: Bridge set number, an integer in the range of 1 to 255.

ip: Specifies the Internet protocol (IP).

ipx: Specifies the internetwork packet exchange (IPX) protocol.

others: Specifies other protocols than IP and IPX.

Use the bridge bridging command to enable bridging of the specified network 
layer protocol(s) on the specified bridge set.

Use the undo bridge bridging command to disable bridging of the specified 
network layer protocol(s) on the specified bridge set.

By default, bridging of all network layer protocols is enabled.

Note that non-routable packets will be discarded if bridging of IP or IPX is disabled 
in a bridge set.

# Disable IP bridging on bridge set 1.

<Sysname> system-view

[Sysname] undo bridge 1 bridging ip 

# Enable IP bridging on bridge set 1.

<Sysname> system-view

[Sysname] bridge 1 bridging ip 

System view

None