3com MSR 20-20 참조 매뉴얼

C

HAPTER

 36: B

RIDGING

 C

ONFIGURATION

 C

OMMANDS

deny: Discards frames whose source address or destination address is the 
specified address on all interfaces or the specified interface.

permit: Forwards frames whose source address or destination address is the 
specified address on all interfaces or the specified interface.

interface: Specifies an outbound interface.

interface-type interface-number: Specifies an interface by its name and number.

dlsw: Specified that the outbound interface is a DLSw module.

Use the bridge mac-address command to configure a static bridge table entry.

Use the undo bridge mac-address command to remove a static bridge table 
entry.

# Configure a static bridge table entry so that Ethernet1/0 can forward frames 
with a destination MAC address of 0000-0000-0111.

<Sysname> system-view

[Sysname] bridge 1 mac-address 0000-0000-0111 permit interface ethernet 1/0 

bridge bridge-set routing { ip | ipx }

undo bridge bridge-set routing { ip | ipx }

System view

bridge-set: Bridge set number, an integer in the range of 1 to 255.

ip: Specifies the Internet protocol (IP).

ipx: Specifies the internetwork packet exchange (IPX) protocol.

Use the bridge routing command to enable routing of the specified protocol(s) 
on the specified bridge set.

Use the undo bridge routing command to disable routing of the specified 
protocol(s) on the specified bridge set.

By default, routing of network layer protocols is disabled.

If the bridge set is configured to route the specified protocol, the packets of the 
protocol that need to be routed will be routed.

# Enable IP routing in bridge set 1.

<Sysname> system-view

[Sysname] bridge 1 routing ip