Avaya 4621SW 사용자 가이드

1. At the Teleworker client telephone, access the User Options menu as described in 

2. Select Teleworker on the User Options menu, or press 8 on the dialpad.

3. Select Status on the Teleworker menu, or press 2 on the dialpad. 

One of the following messages is displayed: 

●

When Local (No Teleworker) is displayed, Teleworker mode has not been enabled. 
See 

 to enable Teleworker mode. 

●

When Idle is displayed, Teleworker mode is enabled and the telephone is idle.

●

When Connecting... is displayed, the Teleworker client telephone is attempting to 
connect to a Teleworker server host—a session has not been established. The host IP 
address of the Teleworker server is also displayed in the display area.

●

When Connected is displayed, the Teleworker client telephone has connected to the 
Teleworker server host successfully and can access the remote one-X Quick Edition 
network. The host IP address of the Teleworker server is also displayed in the display 
area.

●

When No Server is displayed, an IP address for the remote Teleworker server host is 
required but has not been specified. See 

on page 83 to specify the IP address.

Note:

A Teleworker client telephone cannot act as a server for another Teleworker client 
telephone. If an IP address has been specified and the IP address belongs to a 
Teleworker client telephone, the No Server message will be displayed.

●

When Not Authorized is displayed, the Teleworker server host does not recognize the 
Teleworker client telephone and the Teleworker server host refuses the connection. 

●

When Restart Required is displayed, the Teleworker server has uploaded a new 
configuration to the Teleworker client telephone. The configuration will not take effect 
until the Teleworker client telephone is restarted. Press the OK softkey to restart the 
Teleworker client telephone.

●

When Server Busy is displayed, the Teleworker server host is occupied with 
connections to two other Teleworker client telephones and cannot accept a third 
connection. The Teleworker client telephone will contact another Teleworker server 
host for a connection automatically.

●

When No Response is displayed, the Teleworker server host was unable to 
acknowledge the connection request from the Teleworker client telephone within a 
predetermined amount of time. If the Teleworker server host is unavailable, it may be 
because your Internet connection is down, your router or firewall has not been 
configured to pass P2P packets through a VPN tunnel correctly, or the Teleworker 
server host has been disconnected from the one-X Quick Edition network. Provided