Netgear WNDAP620 – ProSAFE 3x3 Single Radio, Dual Band Wireless-N Access Point 참조 매뉴얼
Introduction
8
ProSAFE Premium 3 x 3 Dual-Band Wireless-N Access Point WNDAP620
System Requirements
Before installing the wireless access point, make sure that your system meets these
requirements:
requirements:
•
A 10/100/1000 Mbps local area network device such as a hub or switch
•
The Category 5 UTP straight-through Ethernet cable with RJ-45 connector included in the
package, or one like it
package, or one like it
•
A 100–120V, 50–60 Hz AC power source
•
A computer with the TCP/IP protocol installed and a web browser for configuration, such
as Microsoft Internet Explorer 6.0 or later, or Mozilla 1.5 or later
•
An 802.11a/n- or 802.11b/g/n-compliant device, such as the NETGEAR N600 Wireless-N
Dual Band USB Adapter (WNDA3100)
Key Features and Standards
•
•
•
•
The wireless access point is easy to use and provides solid wireless and networking support.
It also offers a wide range of security options.
It also offers a wide range of security options.
Supported Standards and Conventions
The wireless access point supports the following standards and conventions:
•
Standards compliance. The wireless access point complies with the IEEE 802.11a/b/g
standards for wireless LANs and is Wi-Fi certified for 802.11n standard.
standards for wireless LANs and is Wi-Fi certified for 802.11n standard.
•
WPA and WPA2. The wireless access point provides WPA and WPA2 enterprise-class
strong security with RADIUS and certificate authentication as well as dynamic encryption
key generation. The WPA-PSK and WPA2-PSK pre-shared key authentication does not
have the overhead of RADIUS servers but provides the strong security of WPA.
strong security with RADIUS and certificate authentication as well as dynamic encryption
key generation. The WPA-PSK and WPA2-PSK pre-shared key authentication does not
have the overhead of RADIUS servers but provides the strong security of WPA.
•
Multiple BSSIDs. The wireless access point supports multiple BSSIDs. When a wireless
access point is connected to a wired network and a set of wireless stations, it is called a
basic service set (BSS). The basic service set identifier (BSSID) is a unique identifier
attached to the header of packets sent over a WLAN that differentiates one WLAN from
another when a mobile device tries to connect to the network.
access point is connected to a wired network and a set of wireless stations, it is called a
basic service set (BSS). The basic service set identifier (BSSID) is a unique identifier
attached to the header of packets sent over a WLAN that differentiates one WLAN from
another when a mobile device tries to connect to the network.
The multiple BSSID feature allows you to configure up to 16 SSIDs (8 per radio, but only
one radio can be active at a time) on your wireless access point and assign different
configuration settings to each SSID. All the configured SSIDs are active, and the network
devices can connect to the wireless access point by using any of these SSIDs.
one radio can be active at a time) on your wireless access point and assign different
configuration settings to each SSID. All the configured SSIDs are active, and the network
devices can connect to the wireless access point by using any of these SSIDs.