Netgear XCM8806 - 8800 SERIES 6-SLOT CHASSIS SWITCH 사용자 설명서
Chapter 15. QoS
|
373
NETGEAR 8800 User Manual
•
These switches allow dynamic creation and deletion of QoS queues, with QP1 and QP8
always available.
•
ACL egress rate-limit meters are supported.
Configuration Summary for NETGEAR 8800 Switches
Use the following procedure to configure QoS on NETGEAR 8800 switches:
1.
Configure basic Layer 2 connectivity (prerequisite).
2.
3.
Configure ingress and egress rate-limiting as needed:
a. Create a meter as described in
b. Configure the meter as described in
c. Apply the meter to ingress traffic as described in
4.
Configure non-ACL-based egress QoS profile selection as described in the following
sections:
sections:
5.
Configure 802.1p or DiffServ packet marking as described in
6.
Configure egress QoS profile rate shaping as needed:
a. Create egress QoS profiles as described in
b. Configure egress QoS profile rate shaping parameters as described in
7.
Configure egress port rate shaping as described in
8.
Finalize ACL traffic-based group configuration as described in
9.
Verify the configuration using the commands described in
Selecting the QoS Scheduling Method
QoS scheduling determines the order of QoS profile service and varies between platforms.
The NETGEAR 8800 switches support two QoS scheduling methods: strict-priority and
weighted-round-robin. These scheduling methods are described in
The NETGEAR 8800 switches support two QoS scheduling methods: strict-priority and
weighted-round-robin. These scheduling methods are described in
The scheduling applies globally to all ports on the switch, but you can override the
weighted-round-robin configuration on a QoS profile.
weighted-round-robin configuration on a QoS profile.