Netgear FVS336Gv2 – ProSafe Dual WAN Gigabit Firewall with SSL & IPSec VPN 참조 매뉴얼

In the upper right, select the IPv6 radio button. 

The DMZ Setup screen displays the IPv6 settings. 

In List of IPv6 Address Pools table, select the check box to the left of each address pool 
that you want to remove or click the Select All button to select all address pools.

Click the Delete button.

The selected IPv6 address pools are removed from the List of IPv6 Address Pools table.

The following sections provide information about managing static IPv6 routing:

NETGEAR’s implementation of IPv6 does not support RIP next 
generation (RIPng) to exchange routing information, and dynamic 
changes to IPv6 routes are not possible. To enable routers to 
exchange information over a static IPv6 route, you must manually 
configure the static route information on each router.

The following procedure describes how to add an IPv6 static route to the VPN firewall.



On your computer, launch an Internet browser.

In the address field of your browser, enter the IP address that was assigned to the VPN 
firewall during the installation process.

The VPN firewall factory default IP address is 192.168.1.1.

The NETGEAR Configuration Manager Login screen displays.

In the Username field, type your user name and in the Password / Passcode field, type 
your password.

For the default administrative account, the default user name is admin and the default 
password is password.

If you changed the default domain or were assigned a domain, from the Domain menu, 
select the domain.

If you did not change the domain or were not assigned a domain, leave the menu 
selection at geardomain.