Netgear WN203 - ProSAFE® WIRELESS-N SINGLE BAND ACCESS POINT 사용자 설명서
Troubleshooting
100
ProSAFE Single Band 802.11n Wireless Access Point WN203
Basic Functioning
This section describes how you can use the LEDs to troubleshoot the wireless access point.
•
•
•
•
Note:
Verify the Correct Sequence of Events at Startup
After you turn on power to the wireless access point, check that the following
sequence of events occurs:
•
The Power LED is green. If the Power LED is off, check the connections, and check if the
power outlet is controlled by a wall switch that is turned off.
power outlet is controlled by a wall switch that is turned off.
•
The Test LED is amber. After about one minute, the Test LED turns off.
•
The LAN LED indicates the LAN speed for the LAN port: green for 1000 Mbps or amber
for 100 Mbps or 10 Mbps.
for 100 Mbps or 10 Mbps.
•
The WLAN LED is blue when the wireless LAN (WLAN) is ready.
If any of these conditions does not occur, see the appropriate following section.
No LEDs Are Lit on the Wireless Access Point
It takes a few seconds for the Power LED to light. Wait 15 seconds and check the Power LED
status on the wireless access point.
status on the wireless access point.
If the wireless access point has no power and you use a PoE switch to provide power
to the wireless access point:
to the wireless access point:
•
Make sure that the Ethernet cable between the wireless access point and the PoE switch
is connected correctly at both ends.
is connected correctly at both ends.
•
Make sure that the power cord of the PoE switch is plugged into a working power outlet or
power strip.
power strip.
•
Make sure that the PoE switch is functioning normally.