Netgear WAG302v2- ProSAFE Dual Band Wireless Access Point 참조 매뉴얼

Management and Information

3-3

The WAG302v2 includes a secure Telnet command line interface (CLI). You can access the CLI 
from a secure Telnet client over the Ethernet port or over the serial console port. 

1. Using a null-modem cable, connect a VT100/ANSI terminal or a workstation to the port 

labeled Console.

If you attached a PC, Apple Macintosh, or UNIX workstation, start a secure terminal-
emulation program.

2. Configure the terminal-emulation program to use the following settings:

•

Baud rate: 9600 bps

•

Data bits: 8

•

Parity: none

•

Stop  bit:  1

•

Flow control: none

These settings appear below the connector on the back panel.

3. Press Enter, and a screen similar to the one in 

 should appear.

4. The the login name and password. The login name is admin and password is the default 

password. 

Note: You must use a secure Telnet client such as PuTTY. Also, when you configure the 

client, use the SSH1, 3DES option. If you use the Telnet client to connect over the 
Ethernet port, use the IP address of the WAG302v2 as the host name.