Netgear WNR2200 - N300 Wireless Router 설치 가이드

Troubleshooting

28

Verify that your LAN-connected computers are configured to obtain an IP address 
automatically through DHCP. For help with this, see the documentation for your computer or 

Verify whether the MAC address is needed. Some cable modem services require you to use 
the MAC address of the computer registered on the account. If this is the case, in the Router 
MAC Address section of the Basic Settings screen, select Use this Computer’s MAC 
Address. To save your settings, click Apply. Restart the network in the correct sequence.

If the Power light does not turn solid green within 2 minutes after you turn the router on, reset the 
router according to the instructions in 

.

After you turn on power to the router, check that the following sequence of events has occurred:

1. When power is first applied, verify that the Power light is on and that it is solid amber while 

the router boots up (see 

 for an illustration).

2. Verify that the Power light turns amber within a few seconds, indicating that the self-test 

procedure is running.

3. After approximately 90 seconds, verify that:

The color of the Power light changes to green.

The LAN port lights are lit for any local ports that are connected.

If a port’s light is lit, a link has been established to the connected device. If a LAN port is 
connected to a 100 Mbps device, verify that the port’s light is green. If the port is 10 
Mbps, the light will be amber.

The Internet port is connected and its light is lit.

4. If you have enabled WPS security, verify that the WPS button light on the front panel turns off.

If the correct behavior does not occur, check for a remedy from the following table.