Netgear WNR2020v2 - 5PT N300 Wireless Router 사용자 설명서

Does your computer or wireless device support the security that you are using for 
your WiFi network (WEP, WPA, or WPA2)? 

Did you set up a wireless access list in the router?

If you set up an access list, you must add the MAC address for each computer and 
wireless device to the list. For more information about access list settings, see 

If the router does not save the changes you make through the NETGEAR genie screens, 
check the following:

When you log in to the router and change the settings on a screen, always click the Apply 
button before you move to another screen or tab, or your changes are lost. 

Click the Refresh or Reload button in the web browser. The changes might have 
occurred, but the old settings might be in the web browser’s cache.

The LEDs on the front panel of the router indicate its status.



Connect the power adapter cord that came with the router and plug it in to a power 

outlet. 

The Power LED lights and turns amber within a few seconds. This indicates that the 
self-test is running.

After approximately 30 seconds, verify that the LEDS are lit as follows:

The Power LED 

 is lit solid green.

The WiFi LED 

 is lit solid green. 

The Internet LED 

 is lit solid green.

The Ethernet LEDs (1 through 4) 

 are lit solid green or solid amber for 

any computers cabled to the router by an Ethernet cable.

If the LEDs do not light as expected, use the LED behavior to troubleshoot the problem.