Netgear WNR2020v2 - 5PT N300 Wireless Router 사용자 설명서

When the router is turned on, the LEDs light for about 10 seconds and then turn off. If all the 
LEDs stay lit, a fault exists within the router.

If all LEDs are still lit one minute after power-up, try the following:

Unplug the router’s power adapter cord. Plug it in again and see if the router recovers.

To return the router to its factory settings, press and hold the Reset button. 

If the error persists, you might have a hardware problem. Contact technical support at 

.

If the Power LED 

 is Off or blinking, try the following:

Make sure that the power adapter cord is securely connected to your router and securely 
connected to a functioning power outlet. 

Make sure that you are using the power adapter cord that NETGEAR supplied for this 
product.

If the Power LED blinks slowly and continuously, the router firmware is corrupted. This 
situation can happen if a firmware upgrade is interrupted, or if the router detects a 
problem with the firmware. If the error persists, you have a hardware problem. For 
recovery instructions or help with a hardware problem, contact technical support at 

.

When the router is turned on, the Power LED 

 turns amber for about 20 seconds and 

then turns green. If the LED does not turn green, the router has a problem.

If the Power LED is still amber one minute after you turn on power to the router, try the 
following:

Unplug the router’s power adapter cord. Plug it in again and see if the router recovers.

To return the router to its factory settings, press and hold the Reset button. 

If the error persists, you might have a hardware problem. Contact technical support at 

.

If the Internet LED 

 does not light, check the following: