SINGER SEQS-6000 FUTURA QUARTET 지침 매뉴얼

Now you are prompted to select the

Program Folder where

the shortcut for the software will be stored.

Simply click on

“Next” to continue.

Finally you are requested to confirm all the selections made

during the installation set-up.

Pressing the

“Next” button will finally start the copy and

installation of the FUTURA software files to the given

directory on the hard disk.

progress bar will indicate the stage at which the installation

procedure is. It will finish when it has reached to

100%.

The installation procedure is finalizing all required actions and

will automatically close after finish. Please wait for a short

while until this happens.

If the installation utility identifies

a lack of available space

on your hard disk, an error message will prompt you to free

some hard disk space before proceeding with the installation.

You can always abort the installation procedure by clicking on

“Cancel”.

CORRECT START-UP PROCEDURE

WHEN EMBROIDERING

The following steps must be followed for proper start-up

protocol. If these steps are not followed precisely, you will

get a “Transmission Pending” error message.
Boot up your computer, but do not open the Futura

software. Next attach the embroidery unit to your sewing

machine and connect the USB cable between your

computer and sewing machine.
1. Turn on your sewing machine. Make sure the needle has

been moved to the highest position by turning the Hand

wheel towards you.

2. Attach the hoop that you plan to work with to your

embroidery unit.

3. Double click on the Futura Icon on your desktop to

open up the Futura Software.

4. You are now ready to select and transmit a design to

your machine.

IMPORTANT: If you have embroidered using the small

hoop, and you are now ready to use your large hoop.

Turn off your machine, close the Futura software and then

turn OFF your computer. Wait for a moment, turn on your

computer and then follow steps 1 through 4 above.