Cisco Cisco TelePresence Video Communication Server Expressway
Enabling endpoints registered on the video network to call MOC clients registered on OCS
5. For SIP over TLS configure the following fields:
SIP mode
On
SIP port
5061 (or the value that is the same as that configured on OCS for
Cisco VCS access over TLS)
Cisco VCS access over TLS)
SIP transport
TLS
Not recommended, but if SIP over TCP is used, configure the following fields:
SIP mode
On
SIP port
5060 (or the value that is the same as that configured on OCS for
Cisco VCS access over TCP)
Cisco VCS access over TCP)
SIP transport
TCP
6. For TLS and TCP configure the following fields:
H.323 mode
Off (H.323 access is not required for communication with OCS)
In the Location section:
Peer 1 address
Peer 1 address
FQDN of an OCS Director or an FEP as appropriate
In the Location section:
Peer 2 address
Peer 2 address
FQDN of an OCS Director or an FEP as appropriate
In the Location section:
Peer 3 address
Peer 3 address
FQDN of an OCS Director or an FEP as appropriate – if any more
than 2
than 2
In the Location section:
Peer 4 address
Peer 4 address
FQDN of an OCS Director or an FEP as appropriate – if any more
than 3
than 3
In the Location section:
Peer 5 address
Peer 5 address
FQDN of an OCS Director or an FEP as appropriate – if any more
than 4
than 4
In the Location section:
Peer 6 address
Peer 6 address
FQDN of an OCS Director or an FEP as appropriate – if any more
than 5
than 5
In the Advanced section:
Zone profile
Microsoft Office Communications Server 2007
7. Click
Save.
Note: Do not worry about the status section indicating
Failed
. This will change to
Active
once the
zone’s IP address / FQDN has been saved.
If there are more than 6 FEPs behind the main Hardware load balancer, add further neighbor zones
(each with unique names) until all FEPs are referenced as a Peer x Address.
(each with unique names) until all FEPs are referenced as a Peer x Address.
Note: Do not configure any Search rules to point to these zones. These zones are receive only.
Calls can now be made between SIP and H.323 endpoints registered on the Video Network to MOC
clients registered on OCS.
clients registered on OCS.
Testing the configuration
Test calls from endpoints registered on the video network to MOC clients registered on OCS.
For example, call steve.hight@test-customer.com or mary.jones@test-customer.com from both SIP
and H.323 endpoints registered on Cisco VCS Control.
and H.323 endpoints registered on Cisco VCS Control.
Cisco VCS Deployment Guide: Microsoft OCS 2007 R1 and R2 and Cisco VCS X5.2
Page 50 of 92