Cisco Cisco Aironet 1522 Lightweight Outdoor Mesh Access Point 설치 가이드

Open the electrical joint compound (supplied), and apply a liberal amount over the metal surface where 
the ground strap screw holes are located (see 

). 

Connect the grounding lug to the access point grounding screw holes (see 

) using the supplied 

two Phillips head screws (M4 x10 mm) with lock washers. Tighten the grounding screw to
22 to 24 in. lbs (2.49 to 2.71 Nm). 

If necessary, strip the other end of the ground wire, and connect it to a reliable earth ground such as a 
grounding rod (see 

), an appropriate grounding point on a metal streetlight pole that is grounded 

(see 

), or a grounded cable on a cable strand.

The fiber-optic kit (GLC-FE-100BX-URGD=) enables the access point to support fiber-optic network 
connections. The kit contains these parts:

100BASE-BX10-U rugged SFP module

Single strand fiber bidirectional optical transceiver

1.3/1.5 micro-meter wavelength division multiplexing (WDM) function

125-Mb/s data rates

Single mode LC receptacle

Eight screws

Two small take-up reels

Two large take-up reels

One liquid tight adapter—accepts a cable diameter of 0.20 to 0.35 in. (0.51 to 0.89 cm)

Class 1 laser product. Statement 1008

You need a customer supplied outdoor-rated fiber-optic cable with an LC connector. The cable diameter 
must be 0.20 to 0.35 in. (0.52 to 0.89 cm) in diameter.

To connect a fiber-optic cable to the access point, follow these steps:

Ensure that all power sources have been disconnected from the access point.

This unit might have more than one power supply connection. All connections must be removed to 
de-energize the unit. Statement 1028

If your access point contains a backup battery pack, you must depress the reset button for
10 seconds or more (see the

 

).