These warnings are translated into several languages in the Regulatory Compliance and Safety Information for the Cisco
IW3702 Access Point on Cisco.com.

Warning:

Only trained and qualified personnel should be allowed to install, replace, or service this equipment.

Statement 1030

Warning:

In order to comply with FCC radio frequency (RF) exposure limits, antennas for this product should be

located a minimum of 7.9 in. (20 cm) or more from the body of all persons. Statement 332

Warning:

Read the installation instructions before you connect the system to its power source. Statement 1004

Warning:

This unit is intended for installation in restricted access areas. A restricted access area can be accessed

only through the use of a special tool, lock and key, or other means of security. Statement 1017

Warning:

This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the

absence of a suitably installed ground conductor. Contact the appropriate electrical inspection authority or an
electrician if you are uncertain that suitable grounding is available. Statement 1024

Warning:

Ultimate disposal of this product should be handled according to all national laws and regulations.

Statement 1040

Warning:

To prevent the system from overheating, do not operate it in an area that exceeds the maximum

recommended ambient temperature of: 70°C Statement 1047

Warning:

Installation of the equipment must comply with local and national electrical codes. Statement 1074

Warning:

This product relies on the building’s installation for short-circuit (overcurrent) protection. Ensure that the

protective device is rated not greater than: 15 A. Statement 1005

Warning:

Do not operate your wireless network device near unshielded blasting caps or in an explosive

environment unless the device has been modified to be especially qualified for such use. Statement 245B

Caution:

The fasteners you use to mount an access point on a ceiling must be capable of maintaining a minimum pullout

force of 20 lbs (9 kg) and must use all 4 indented holes on the mounting bracket.

Note:

The access point is suitable for use in environmental air space in accordance with section 300.22.C of the National

Electrical Code and sections 2-128, 12-010(3), and 12-100 of the Canadian Electrical Code, Part 1, C22.1. You should
not install the power supply or power injector in air handling spaces.

Note:

Use only with listed ITE equipment.