Cisco Cisco Aironet 1200 Access Point 릴리즈 노트
6
Release Notes for 1200 Series Access Points for Cisco IOS Release 12.2(8)JA
OL-3448-01
Important Notes
Antenna Installation
For instructions on the proper installation and grounding of external antennas for 1200 series access
points, refer to the National Fire Protection Association’s NFPA 70, National Electrical Code, Article
810, and the Canadian Standards Association’s Canadian Electrical Code, Section 54.
points, refer to the National Fire Protection Association’s NFPA 70, National Electrical Code, Article
810, and the Canadian Standards Association’s Canadian Electrical Code, Section 54.
Warning
Do not install the antenna near overhead power lines or other electric light or power circuits, or
where it can come into contact with such circuits. When installing the antenna, take extreme care
not to come into contact with such circuits, as they may cause serious injury or death.
where it can come into contact with such circuits. When installing the antenna, take extreme care
not to come into contact with such circuits, as they may cause serious injury or death.
Important Notes
This section describes important information about the access point.
Radio MAC Address Appears in ACU
When a Cisco Aironet client device associates to a 1200 series access point running IOS, the access point
MAC address that appears on the Status page in the Aironet Client Utility (ACU) is the MAC address
for the access point radio. The MAC address for the access point Ethernet port is printed on the label on
the back of the access point.
MAC address that appears on the Status page in the Aironet Client Utility (ACU) is the MAC address
for the access point radio. The MAC address for the access point Ethernet port is printed on the label on
the back of the access point.
Radio MAC Address Appears in Access Point Event Log
When a client device roams from an access point (such as access point alpha) to another access point
(access point bravo), a message appears in the event log on access point alpha stating that the client
roamed to access point bravo. The MAC address that appears in the event message is the MAC address
for the radio in access point bravo instead of the Ethernet port in access point bravo.
(access point bravo), a message appears in the event log on access point alpha stating that the client
roamed to access point bravo. The MAC address that appears in the event message is the MAC address
for the radio in access point bravo instead of the Ethernet port in access point bravo.
Mask Field on IP Filters Page Behaves the Same as in CLI
In Cisco IOS Release 12.2(8)JA, the mask that you enter in the Mask field on the IP Filters page in the
access point GUI behaves the same way that a mask behaves when you enter it in the CLI. If you enter
255.255.255.255 as the mask, the access point accepts any IP address. If you enter 0.0.0.0, the access
point looks for an exact match with the IP address that you entered in the IP Address field.
access point GUI behaves the same way that a mask behaves when you enter it in the CLI. If you enter
255.255.255.255 as the mask, the access point accepts any IP address. If you enter 0.0.0.0, the access
point looks for an exact match with the IP address that you entered in the IP Address field.