Cisco Cisco Aironet 2600e Access Point 설치 가이드

Access points mounted in a building’s environmental airspace must be powered using PoE to comply with safety 
regulations.

Cisco recommends that you make a site map showing access point locations so that you can record the device MAC addresses 
from each location and return them to the person who is planning or managing your wireless network.

Installing the access point involves these operations:

Performing a pre-installation configuration (optional)

Mounting the access point

Grounding the access point

Deploying the access point on the wireless network

The following procedures ensure that your access point installation and initial operation go as expected. A pre-installation 
configuration is also known as priming the access point. This procedure is optional.

Performing a pre-installation configuration is an optional procedure. If your network controller is properly configured, 
you can install your access point in its final location and connect it to the network from there. See the 

 for details.

The pre-installation configuration setup is shown in 

.

To perform pre-installation configuration, perform the following steps:

Controller

Layer 3

devices

Cisco Aironet

access points

272488