Cisco Cisco Aironet 2600e Access Point Guía De Instalación
9
Note
Access points mounted in a building’s environmental airspace must be powered using PoE to comply with safety
regulations.
regulations.
Cisco recommends that you make a site map showing access point locations so that you can record the device MAC addresses
from each location and return them to the person who is planning or managing your wireless network.
from each location and return them to the person who is planning or managing your wireless network.
Installation Summary
Installing the access point involves these operations:
•
Performing a pre-installation configuration (optional)
•
Mounting the access point
•
Grounding the access point
•
Deploying the access point on the wireless network
Performing a Pre-Installation Configuration
The following procedures ensure that your access point installation and initial operation go as expected. A pre-installation
configuration is also known as priming the access point. This procedure is optional.
configuration is also known as priming the access point. This procedure is optional.
Note
Performing a pre-installation configuration is an optional procedure. If your network controller is properly configured,
you can install your access point in its final location and connect it to the network from there. See the
you can install your access point in its final location and connect it to the network from there. See the
for details.
Pre-Installation Configuration Setup
The pre-installation configuration setup is shown in
.
Figure 4
Pre-Installation Configuration Setup
To perform pre-installation configuration, perform the following steps:
Controller
Layer 3
devices
Cisco Aironet
access points
272488