Cisco Cisco Aironet 1040 Series Access Point 설치 가이드

You need the following tools and equipment to install the mounting kit:

A table or work surface suitable for cutting the ceiling tile

A pencil, pen, or marker

A sharp knife, keyhole saw, or rotary zip-style tool for cutting the ceiling tile

A small hammer to tap down retaining tabs (optional)

Two support blocks, such as phone books or wooden blocks, approximately 1¼-inches thick

A ladder high enough to reach the mounting location

Follow these steps to install the mounting kit:

Determine the location at which you intend to install the access point.

Make sure that the location you select has adequate space for the access point and cable routing.

Remove the ceiling tile from the ceiling.

Put the trim bezel on the center of the tile and trace around the inside of the bezel.

Cut a hole in the tile using the tracing as a pattern. Make the hole approximately one-eighth inch larger 
than the tracing so the body of the access point will fit into the hole.

If you need to install several mounting kits, you can simplify tile-cutting with a rotary zip-style cutting 
tool. Instead of tracing around the bezel as described above, you can use a cutting template such as the 
one offered by Oakdale Precision at this URL:

Snap the bezel onto the access point. With the access point face-up on your work surface, put the bezel 
on with the painted side facing up. The bezel fits on over the top of the access point; it does not fit over 
the back.

The wide tabs on the bezel fit onto the bottom and top of the access point and the narrow tabs fit onto 
the sides. Start by engaging the wide tab on the bottom of the access point, then engage the sides, and 
then the wide tab on the top. The numbers in 

 show the ideal order for engaging the tabs.

If the bezel seems difficult to snap on, one of the tabs might have disengaged. If a tab is 
disengaged, remove the bezel and start again. Excessive force can distort or damage the bezel.