Cisco Cisco Aironet 1810w Access Point 문제 해결 가이드
WLC Example for Local Switching of LAN Port Data on AP Ethernet Port
Complete these steps:
Create a RLAN on the WLC. Click Apply.
Note: MAC filtering is enabled by default when a new RLAN is created. Be sure to disable if
not used.
not used.
1.
Once created, click RLAN. Enable the RLAN and click the Advanced tab.
2.
Check the FlexConnect Local Switching checkbox. In the VLAN Id field enter the VLAN ID
to which this RLAN will map LAN Port data locally at the AP. Click Apply in order to save
changes.
to which this RLAN will map LAN Port data locally at the AP. Click Apply in order to save
changes.
Note: If FlexConnect Local Switching is enabled on the RLAN, but the AP is in Local Mode,
LAN port data will centrally switch on the WLC to the dynamic interface on which the RLAN is
mapped.Note: If Local Switching is enabled on the RLAN, the LAN port data will always be
LAN port data will centrally switch on the WLC to the dynamic interface on which the RLAN is
mapped.Note: If Local Switching is enabled on the RLAN, the LAN port data will always be
3.