Cisco Cisco Aironet 1400 Wireless Bridge 설치 가이드
10
Cisco Aironet 1400 Series Outdoor Wireless Bridge 28-dBi Dish Antenna
78-15547-01
Installation Notes
Note
If the Install LED changes to continuous amber, the bridge incorrectly associated with another
bridge. Turn off the interfering bridge and then restart this procedure.
bridge. Turn off the interfering bridge and then restart this procedure.
Step 4
Power up the non-root bridge and position its antenna.
Step 5
Return to the root bridge and position its antenna using LED indications or RSSI voltages. For more
information, see the
information, see the
Activating the Non-Root Bridge
To activate and align the non-root bridge, follow these following steps:
Step 1
Apply power and observe the bridge LEDs.
Step 2
Wait for the bridge to cycle through the following initialization and association states:
Step 3
If the Install LED starts blinking green, the non-root bridge failed to associate with the root bridge.
Power cycle the bridge, wait for the Install LED to blink amber, and then slowly pan the antenna left to
right or tilt it up and down until the Install LED changes to amber. In the default configuration, you have
only 60 seconds to achieve association.
Power cycle the bridge, wait for the Install LED to blink amber, and then slowly pan the antenna left to
right or tilt it up and down until the Install LED changes to amber. In the default configuration, you have
only 60 seconds to achieve association.
Step 4
Align the antenna using LED indications or RSSI voltages. For more information, see the
below.
Positioning the Antenna
The goal when positioning the antenna is to align the local antenna for maximum signal strength.
Normally, you observe a single large peak as you pan the antenna across the signal path. However, if the
antennas are not well-positioned during installation, you may observe two peaks of roughly equal
amplitude. Think of the receive signal as a target (see
Normally, you observe a single large peak as you pan the antenna across the signal path. However, if the
antennas are not well-positioned during installation, you may observe two peaks of roughly equal
amplitude. Think of the receive signal as a target (see
).
State
Install LED
Activity
Self test
Off
Power on self test.
Non-root, searching
Amber blinking
The bridge attempts to associate with a root bridge.
Non-root, associated
Amber
The bridge successfully associated with the root bridge.