Cisco Cisco Aironet 350 Workgroup Bridges 릴리즈 노트
F I R S T D R A F T - C I S C O C O N F I D E N T I A L
5
Release Notes for Cisco Aironet 350 Series Workgroup Bridges Running Firmware Release 8.89
OL-6341-01
Caveats
A bridge loop can also occur if two or more workgroup bridges are connected to the same remote hub.
To prevent this bridge loop, always connect only one workgroup bridge to a remote hub.
To prevent this bridge loop, always connect only one workgroup bridge to a remote hub.
shows the network configuration in which the bridge loop occurs.
Figure 2
Bridge Loop Caused by Two Workgroup Bridges on the Same Remote Hub
Caveats
This section describes the resolved caveats for firmware version 8.89.
Getting Bug Information on Cisco.com
If you are a Cisco.com registered user, you can use the Cisco TAC Software Bug Toolkit to identify
existing bugs (or caveats) in Cisco software products. Access the TAC Software Bug Toolkit at:
existing bugs (or caveats) in Cisco software products. Access the TAC Software Bug Toolkit at:
Open Caveats
•
CSCea59101—Signal strength test does not display level until a warm reload is performed.
When the workgroup bridge has been running for a day or more, performing the signal strength test
does not display the signal level bar unless the unit is restarted (warm reloaded) using the Telnet or
browser interface.
does not display the signal level bar unless the unit is restarted (warm reloaded) using the Telnet or
browser interface.
ETHERNET
SPEED
1
5
2
6
3
7
4
8
LED
100BaseTX
SOLID
10BaseT
BLINK
1X 2X
3X 4X
5X
6X
7X
MDI
MDI-X
8X
Wired LAN
Access point
Access point
Workgroup bridge
Workgroup bridge
Hub
44713