Cisco Cisco WAP121 Wireless-N Access Point with Single Point Setup 설치 가이드

Follow the Setup Wizard instructions to finish the WAP device 
installation. We strongly recommend you use the Setup Wizard for 
the first installation.The Setup Wizard turns on the Wi-Fi radio, 
allowing you to connect wirelessly. For advanced configurations, 
see the Administration Guide. A link to the Administration Guide is 
found in 

Congratulations, you can now start using your wireless access point.

In case of an error while installing, try the following troubleshooting 
procedures:

If you cannot display the configuration utility, you can test the ability of the 
computer to communicate with the device by using ping. To use ping on a 
computer running Windows:

Verify that the Cisco WAP121 or WAP321 is powered on and the 
lights indicate the appropriate links.

Locate the device’s IP address. While there are different ways to 
locate your device’s IP address, this procedure uses Cisco FindIT. 

a.

If you have previously downloaded Cisco FindIT, open Internet 
Explorer and launch Cisco FindIT. For more information on 
downloading Cisco FindIT, see www.cisco.com/go/findit.

b. In the Cisco FindIT display, place your mouse over the device’s 

name. The device IP address is displayed along with other 
device information.

Open a command window by using Start > Run and enter cmd.

At the Command window prompt enter ping and the 

address. In this example, we pinged 192.0.2.10. 

If successful, you should get a reply similar to the following:

Pinging 192.0.2.10 with 32 bytes of data:
Reply from 192.0.2.10: bytes=32 time<1ms TTL=128

If it fails, you should get a reply similar to the following:

Pinging 192.0.2.10 with 32 bytes of data:
Request timed out.