Cisco Cisco WAP131 Wireless-N Dual Radio Access Point with PoE 관리 매뉴얼
9
Cisco WAP131 and WAP351 Administration Guide
147
SNMP
This chapter describes how to configure the Simple Network Management
Protocol (SNMP) to perform configuration and statistics gathering tasks. It contains
these topics:
Protocol (SNMP) to perform configuration and statistics gathering tasks. It contains
these topics:
•
•
•
•
•
General
Use the General page to enable SNMP and configure basic protocol settings.
To configure general SNMP settings:
STEP 1
Select SNMP > General.
STEP 2
Enable or disable SNMP on the WAP device. SNMP is disabled by default.
STEP 3
If you enable SNMP, specify a UDP Port for SNMP traffic.
By default, an SNMP agent listens only to the requests from port 161. However,
you can configure it so that the agent listens to the requests on a different port.
The valid range is from 1025 to 65535.
you can configure it so that the agent listens to the requests on a different port.
The valid range is from 1025 to 65535.
STEP 4
In the SNMPv2c Settings area, configure the SNMPv2c settings:
•
Read-only Community—Enter a read-only community name for SNMPv2
access. The valid range is 1 to 256 alphanumeric and special characters.
access. The valid range is 1 to 256 alphanumeric and special characters.