Cisco Cisco WAP571 Wireless-AC N Premium Dual Radio Access Point with PoE 설치 가이드

Verify that the Cisco WAP571 is powered on and the lights indicate 
the appropriate links.

Locate the device’s IP address. While there are different ways to 
locate your device’s IP address, this procedure uses Cisco FindIT.

a.

If you have previously downloaded Cisco FindIT, open Internet 
Explorer and launch Cisco FindIT. For more information on 
downloading Cisco FindIT, see 

www.cisco.com/go/findit

.

b. In the Cisco FindIT display, place your mouse over the device’s 

name. The device IP address is displayed along with other 
device information.

Open a command window by choosing Start > Run and enter 
cmd.

At the command window prompt, enter ping and the device IP 
address. In this example, we pinged 192.0.2.10. 

If successful, you should get a reply similar to the following:

Pinging 192.0.2.10 with 32 bytes of data:
Reply from 192.0.2.10: bytes=32 time<1ms TTL=128

If it fails, you should get a reply similar to the following:

Pinging 192.0.2.10 with 32 bytes of data:
Request timed out.

• Power up the switch and your computer if they are turned off.

• Make sure your PoE switch is powered on and the lights indicate that 

you have a link. See 

• Verify that the devices on your network are not plugged into a 

switchable outlet.

• Check the state of the indicator lights. See 

• Check the Ethernet cable to ensure that it is firmly connected to your 

devices. Devices connected by the Ethernet cable can include the WAP 
device, and routers, any switches, and your computer.

• Verify the connected switch has auto-negotiation enabled. The access 

point and the switch need the same negotiation parameters set.