Cisco Cisco WAP571 Wireless-AC N Premium Dual Radio Access Point with PoE 설치 가이드

After a new firmware installation, if the Power light is solid red, contact 
system support; see 

.

The most likely cause of connectivity failure is an incorrect IP address. The 
Web browser may be pointing to the wrong IP address, or your computer 
may be configured with an IP address that is not in the same subnet as the 
device.

Because the factory default IP address configuration is DHCP, make sure 
that your DHCP server is running and can be reached. You may need to 
disconnect and reconnect the devices for them to discover their new IP 
addresses from the DHCP server. You can then query the DHCP server for 
the new IP address. See 

 for more information on how to find the DHCP 

address.

If the wireless access points do not receive a DHCP response (there is no 
DHCP server on your network) after 60 seconds, the access points will 
fallback to the following default static IP address: 192.168.1.245 and a 
default mask of 255.255.255.0. To reach that IP address, be sure that your 
computer is on the 192.168.1.xxx network.

• The Cisco WAP571 uses PoE power supply; unplug your Ethernet 

connection and plug it back in.

or

• With the power on, press the Reset button with an opened paper clip 

for less than three seconds, or until the lights go off. 

–

When all the lights go off, release the Reset button.

–

Release the Reset button as soon as the lights go off, or you will 
restore the device to factory default settings and lose your 
configurations.