Cisco Cisco Aironet 1200 Access Point 릴리즈 노트
15
Release Notes for Cisco Aironet Access Points for Cisco IOS Release 12.3(8)JEC
OL-14518-01
Important Notes
Cannot Perform Link Tests on Non-Cisco Aironet Client Devices and on Cisco
Aironet 802.11g Client Devices
Aironet 802.11g Client Devices
The link test feature on the web-browser interface does not support non-Cisco Aironet client devices nor
Cisco Aironet 802.11g client devices.
Cisco Aironet 802.11g client devices.
1100 Series Access Points with Boot Loader Version 12.2(4)JA Boot into
Monitor Mode
Monitor Mode
When the Ethernet port is disabled on an 1100 series access point running boot loader version 12.2(4)JA,
the access point boots into monitor mode when it reboots. To avoid this problem, connect the access
point Ethernet port to one of the following:
the access point boots into monitor mode when it reboots. To avoid this problem, connect the access
point Ethernet port to one of the following:
•
a wired LAN
•
the Ethernet port on a PC
Remove power from the access point, and reapply power to reboot the unit. When the access point senses
an Ethernet connection, it boots normally.
an Ethernet connection, it boots normally.
Corrupt EAP Packet Sometimes Causes Error Message
During client authentication, the access point sometimes receives a corrupt EAP packet and displays this
error message:
error message:
Oct 1 09:00:51.642 R: %SYS-2-GETBUF: Bad getbuffer, bytes= 28165
-Process= "Dot11 Dot1x process", ipl= 0, pid= 32
-Traceback= A2F98 3C441C 3C7184 3C604C 3C5E14 3C5430 124DDC
You can ignore this message.
When Cipher Is TKIP Only, Key Management Must Be Enabled
When you configure TKIP-only cipher encryption (not TKIP + WEP 128 or TKIP + WEP 40) on any
radio interface or VLAN, every SSID on that radio or VLAN must be set to use WPA or CCKM key
management. If you configure TKIP on a radio or VLAN but you do not configure key management on
the SSIDs, client authentication fails on the SSIDs.
radio interface or VLAN, every SSID on that radio or VLAN must be set to use WPA or CCKM key
management. If you configure TKIP on a radio or VLAN but you do not configure key management on
the SSIDs, client authentication fails on the SSIDs.
Cisco CKM Supports Spectralink Phones
Cisco CKM (CCKM) key management is designed to support voice clients that require minimal roaming
times. CCKM supports only Spectralink and Cisco 7920 Version 2.0 Wireless Phones.
times. CCKM supports only Spectralink and Cisco 7920 Version 2.0 Wireless Phones.